Fastener Products

For almost any assembly application you can think of, Swagefast™ offers a broad range of fastener types such as blind rivets, Swagebolt pin and collar fasteners, standard nuts and bolts – designed to provide exceptional strength for tougher, more durable structures.

Standard Swagebolt Pins & Collars

  • Two-part fastener that comprises a Swagebolt pin with a defined breakneck and a collar
  • Available in diameters ranging from 10mm to 30mm in carbon steel with round (B), truss (T), countersunk 90°deg (C) or thread head (TH) variations
  • Thread head (TH) fasteners can accommodate a wider grip range if required and are manufactured to your requirements
  • When using thread head (TH) fasteners, it is recommended that a washer (THW) is used on the nut side of the fastener
  • Collars are available in standard (CS), flanged (CF) and low-profile (LP) variations

Step Down (SD) Oversized Swagebolt

  • Two-part fastener that comprises a Swagebolt pin with a defined breakneck and a collar
  • Used for reworked holes and in applications where access is limited
  • The Swagebolt's shank diameter is larger to accommodate the oversized holes; however, the grooved section is either stepped down one or two diameter sizes to accommodate the tool

Blind Rivet Swagebolt (BRL)

  • Used where access is limited to the rear side of the application
  • This fastener works basically like an oversized "pop-rivet"
  • Fastener usage is limited to minimum and maximum grip ranges as well as application suitability

Stump Swagebolt (SL)

  • Two-part fastener – differs from the standard Swagebolt pin in that there is no pintail, making it shorter
  • Used in applications where access is limited
  • The installed properties of the fastener are roughly the same as standard Swagebolts with only a 10-15% reduction of tensile strength and clamp force should low-profile (LP) collars be used

Flush Break Multi Fastener (MGL)

  • Single part fastener ideal for structural assembly
  • Available in three diameter selections: 4.8mm, 6.4mm and 9.5mm
  • Head styles: protruding, truss and countersunk
  • Materials: steel, stainless steel and aluminium
  • Wide grip range that reduces rework times as a result of incorrect grip selection

Flush Break Mono Fastener (MB)

  • Single part fastener, ideal for structural assembly to replace conventional fastening methods, particularly in applications where access is limited
  • Available in aluminium alloy, medium carbon steel and stainless steel, in diameters of 4.8mm and 6.4mm with low-profile (LP) and countersunk (C) head configurations

Flush Break Maxi Fastener (MGB)

  • Two-part Grade 2 fastener that comprises a Swagebolt pin with multiple breaknecks and a collar
  • The fastener has a wide grip range that reduces rework times as a result of incorrect grip selection

Bodytainer Fastener (BF)

  • Two-part fastener that comprises a pin with a defined breakneck groove and a collar
  • Designed to join composite materials to metal framing without damaging the softer material or pulling through
  • Neoprene seal under the head which reduces possible condensation issues by ensuring a water tight seal

Standard Fasteners

Swagefast™'s selection of quality manufactured products encompasses a comprehensive range of standard nuts, bolts, washers and other fasteners to provide the full fastening solution for your application.

© acetechtools. All Rights Reserved.
Creators web india"